1. If bath agent is used in bathing, rinse the bathtub with clean water and wipe dry after use. After each use, rinse the bathtub with clean water in time, drain the accumulated water, and dry it with a soft cloth to prevent the accumulation of water in the ventilation pipe and the rusting of metal parts.
2. During hydromassage, pay attention to avoid sundries or other objects from blocking the water return port, which will cause excessive load on the water pump, cause the water pump to overheat and burn out the water pump.
3. Do not start the water pump when there is no water in the bathtub
4. Do not use hard objects or knives to strike and scratch the surface of the bathtub, and at the same time, do not let cigarette butts or heat sources higher than 80°C touch the surface of the bathtub. Do not use hot water higher than 80°C. Repeated use of hot water will reduce the service life of the cylinder. The correct way is to put cold water first and then hot water. the
5. After using the bathtub, drain the water and disconnect the power supply.
6. Daily cleaning of the bathtub: If the surface of the bathtub is dirty, it can be wiped with a wet towel dipped in a neutral detergent. This process can be repeated three times, and it will be as clean as new. The scale on the surface of the bathtub can be wiped with a soft towel dipped in a mildly acidic detergent, such as lemon juice and vinegar. When disinfecting, disinfectants containing formic acid and formaldehyde are prohibited. Metal fittings don’t need to be wiped down as often. If the water return and nozzle are blocked by hair and other debris, they can be unscrewed and cleaned.
7. Clean the hydraulic friction device: fill the bathtub with hot water at 40°C, add detergent at a dose of 2 grams per liter, start the hydro massage for about 5 minutes, stop the pump to drain water, then fill up with cold water, start the hydro massage for about 3 minutes, and stop the pump Drain and clean the bathtub.
8. If there are scratches or cigarette burns on the surface of the bathtub, just use 2000# water abrasive paper to polish it, then apply toothpaste, and polish it with a soft cloth to be as clean as new.
Post time: May-11-2023